
1. Introduction
First of all, we would like to thank you for choosing the XForce Thruster. Engbo AS has for several
years supplied Volvo Penta with thrusters, distributed as QL thrusters through Volvo Penta
dealers and distributors. In late 2006, Engbo and Volvo Penta agreed that distributing through two
channels and brand names would make our thrusters even more available. Together with Engbo
anchoring and mooring systems, the thrusters constitute a complete system for manoeuvring and
mooring your vessel. The control units on both thrusters and winches are based on the same
moduls, which makes it possible to manoeuvre and anchor using one single wireless remote
control.
To achieve maximum benefit from your XForce thruster, please study this manual properly before
installing and making use of the thruster panels. Keep this manual onboard. Do not hesitate to
contact us if you have any questions.
Best regards,
Engbo AS
IMPORTANT:
• Please read the entire instruction carefully before starting on
the installation work.
• The manufacturer does not assume any liability for the
installation of the thruster panels. Qualified installers should
be familiar with these installation instructions. The
responsibility for the installation rests entirely on the installer.
Compliance with regulations must be ensured by the
installer.
• Faulty installation or connection of any components will
render any warranty given by Engbo AS void.
• XForce Thruster(s) must only be operated by persons with
knowledge of the system.
• Keep main engine(s) running when operating thruster(s) to
ensure enough electrical power.
• Only operate the thruster(s) with the propellers fully
submerged.
WARNING:
• Do not operate the thruster(s) without the belt cover installed.
• Make sure no one is within reach of the rotating propeller(s)
• The propeller(s) must come to a stop before engaging in
opposite direction, otherwise the contactors will burn / fuse.
Kommentare zu diesen Handbüchern