Engbo XF 60 VR Spezifikationen PDF herunterladen (Seite 4)

2. Installation

2.1 Installation- joystick

The joystick panel, (single or double), comes complete with;

• Joystick with gasket and connection plug(s)

• Drill template

• Self tapping screws

• Manual

• Turn off the main switch to the electrical thruster.

• Select the mounting position for the joystick panel. The

desired position must be even and in a location that will

prevent water from rain or sea spray to be able to access the

back of the panel. Remove all grease, dust or dirt before

affixing the drill template.

• Mount the drill template sticker and use a hole saw and a file

to remove all needed area for installation. Pre-drill the four

fastening holes with Ø2,4mm, (3/32”).

• Remove the drill template and remove the red cover film from

the gasket.

• Install the panel carefully and fix it in place with the four black

stainless screws.

• Connect the wires to the panel as shown on the connection

diagram(s).

• The wires are connected by pressing in the button placed

under the hole while the wire is being pushed into the hole.

Release the button when the wire is in place.

• Check for good connection by pulling gently in the wires.

• Correct connection is;

• 1: White

• 2: Brown

• 3: Green

• 4: Yellow

2.2 Installation - touch panel

• Decide where to place the panel.

• Drill a Ø 15 mm hole.

• Thread the panel cable trough the hole. Clean the surface.

• Remove the covering paper on the back of the panel and stick

the panel onto the surface.

• The holes in the panel corners may be used to fasten the

panel with screws if needed. Tighten with care.

NB: For best appearance, be accurate about lining up the panel

before sticking it on.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

Engbo XF 60 VR Spezifikationen Seite 4